3.5-Inch 480×320 TFT 50FPS Touch Screen for Raspberry Pi

Descriptionhis is the 3.5-inch TFT Touch Screen (Resistive) with a high graphic refresh rate of 50Hz. It is compatible with:Raspberry Pi 4 Model B 8GBRaspberry Pi 4 Model B 4GBRaspberry Pi 4 Model B 2GBRaspberry Pi 4 Model B 1GBRaspberry Pi 3 Model B Raspberry Pi 3 Model BRaspberry Pi 3 Model A The touch screen LCD is ready with 320×480 resolution, 50 FPS (Frame per second). Resistive touch control is being supported by the Raspberry Pi OS or Raspbian (directly pluggable). However, we will still need to install the driver for graphic display ��This LCD is compatible with all Raspberry Pi board that has 40-pin GPIO, including the Raspberry Pi Zero and Zero W, WH series.SPECIFICATIONS3.5-inch TFT LCD screen with high-speed SPI interfaceCompatible with the latest Raspberry Pi 4 Model BGraphic drivers can be installed from Github, please refer to the steps hereSupport Raspberry Pi OS/Raspbian, Ubuntu, and Kali Linux Operating SystemMatch perfectly with the 3.5-inch Touch Screen ABS case (not included)It comes with a 2-pin 5V and GND header to power a cooling fan.3.5 inches LCD Spec:Screen Type: TFTLCD Driver : ICILI9486Touch: Resistive Touch ControlTouch Controller: XPT2046Resolution: 480 * 320Refresh Rate: 50HzInterface: SPI (Input 125MHz)Backlight: LEDBacklight Current: 120mAPower: 5VOperating Environment: -20 ~ 70 ℃Size: ~ 89 x 60 x 30mm/3.5 x 2.36 x 1.18″Installing the graphic driver for the LCD on the Raspberry Pi 4 Model B:Please get a microSD card with the latest NOOBS/Raspberry Pi OS/Raspbian, or update the OS.Stack the LCD onto Raspberry Pi, before the graphic driver is installed, the Raspberry Pi will output graphics to an HDMI port, so you will need a monitor, mouse, and keyboard to access the terminal.Access to Raspberry Pi OS through the terminal or SSH too.Install the graphic driver into Raspberry Pi OSExecute the following command:sudo rm -rf LCD-showgit clone https://github.com/goodtft/LCD-show.gitchmod -R 755 LCD-showcd LCD-show/sudo ./MHS35-showAfter this command, the Raspberry Pi will restart and the graphic will be displayed on a 3.5 LCD instead of an HDMI port.The touch screen works without any special driver, as we tested on the latest Raspberry Pi OS (30 July 2020).For more details, please refer to this link: http://www.lcdwiki.com/MHS-3.5inch_RPi_DisplayDOCUMENTWiki page to install the graphic driver and other useful commandsSHIPPING LIST 1 x 3.5-Inch 480×320 TFT 50FPS Touch Screen for Raspberry Pi1 x Touch Pen