LCD 2004 Graphic Smart Display Controller Board

The 2004 LCD Dis­play RepRapDis­count Smart Con­troller with Adapter con­tains an SD-Card read­er, a rotary encoder and a 2004 LCD dis­play. You can eas­i­ly con­nect it to your RAMPS board using the “smart adapter”.After con­nect­ing this pan­el to your RAMPS you don’t need your pc any­more, the Smart Con­troller sup­plies pow­er for your SD card. Fur­ther­more, all actions like cal­i­bra­tion, axes move­ments can be done by just using the rotary encoder on the Smart Con­troller. Print your 3D designs with­out PC, just with a g‑code design stored on the SD card.Mar­lin V1 (new)We have pro­vid­ed the Arduino Code to Start smart LCD with RAMPS. You have to open the “Arduino code pdf “(Which is Pro­vid­ed below )  and go to “Configuration.h”and change asInstallation: In “Configuration.h”Change “#define REPRAP_DISCOUNT_SMART_CONTROLLER” (just remove the // at the begin­ning)Upload the code, pow­er off the Arduino, con­nect the pan­el, reap­ply pow­er, and every­thing should work.orStep 1: Down­load and install U8glib to your ARDUINO IDE’s library fold­erU8glib Web­siteU8glib Down­load URLStep 2: Edit Configuration.h in Mar­lin firmware, Search and Uncom­ment (just remove the // at the begin­ning)#define REPRAP_DISCOUNT_FULL_GRAPHIC_SMART_CONTROLLERStep 3: Then Com­pile and Upload the firmwareStep 4: Pow­er off the Arduino, con­nect the pan­el, reap­ply pow­er, and every­thing should work.Features :RAMPS 1.4 2004 LCD Dis­play intel­li­gent con­troller.LED back­ground light con­trol cir­cuit, a small func­tion of the intel­li­gent con­troller, With pin short time to decide on all LED turn or steer­ing 30 sec­ondsYou can turn on the light time to do the long or short form of the adjust­ment TRIMM R4100K from 10 sec­onds to 2 min­utes.Plug and play on the RAMPS, but need to mod­i­fy the firmware to sup­port.The prod­uct comes encoder para­me­ter adjust­ment can be achieved, and the file selec­tion print.With an SD card base on the back, put slic­ing file into the SD card and select the file on the LCD, then can be print­ing.