Raindrops Detection Sensor Module

Large Area Rain Sensor DC 3V 5V Weather Raindrops Rainwater Module Rain Sensors With Digital & Analog Output. The Rain Water Sensor Module can detect whether a conductive liquid such as water has touched the PCB. The module allows you to measure moisture via analog output pins and it provides a digital output when a threshold of moisture is exceeded. It includes the electronics module and a printed circuit board that “collects” the raindrops. As raindrops are collected on the circuit board, they create paths of parallel resistance that are measured via the op-amp LM393. The lower the resistance (or the more water), the lower the voltage output. Conversely, the less water, the greater the output voltage on the analog pin. A completely dry board for example will cause the module to output five volts.SpecificationsThe specifications of the rain sensor include the following.This sensor module uses good quality double-sided material.Anti-conductivity & oxidation with long-time useThe area of this sensor includes 5cm x 4cm and can be built with a nickel plate on the sideThe sensitivity can be adjusted by a potentiometerThe required voltage is 5VThe size of the small PCB is 3.2cm x 1.4cmFor easy installation, it uses bolt holesIt uses an LM393 comparator with a wide voltageThe output of the comparator is a clean waveform and the driving capacity is above 15mAPin ConfigurationThe pin configuration of this sensor is shown below. This sensor includes four pins which include the following.Pin1 (VCC): It is a 5V DC pin.Pin2 (GND): it is a GND (ground) pin.Pin3 (DO): It is a low/ high output pin.Pin4 (AO): It is an analog output pin.Connection mode:VCC: positive power supply (3-5V).GND: negative.DO: TTL switching signal output.AO: Analog signal output.Package:1x Rain Drop Sensor for Arduino.